Filter
Top Products
1-21 (E)
BKP-7933
Changing the Operation Mode of the RCP PREVIEW Switch
The operation mode of the RCP PREVIEW switch can be changed on the CNU-700 character display.
Use the switches on the AT board inside the CNU-700 for this setting.
1. Set the MODE switch to 5.
The message “INTERNAL MODE SETTING” appears on the character monitor display.
2. Set the SET/CANCEL switch to the SET position. The INTERNAL MODE SETTING display
appears.
3. Select “RCP preview MOMENTARY & ALTERNATE” with the UP/DOWN switch. Set the SET/
CANCEL switch to the SET position.
4. Select the desired operation mode (MON/ALT/ALT1) with the UP/DOWN switch. Set the SET/
CANCEL switch to the SET position. Each operation mode is described below.
MON: The preview display appears only while the RCP PREVIEW switch is being pressed.
ALT: The preview display appears when the RCP PREVIEW switch is pressed once, and disap-
pears when it is pressed again.
ALT1: The preview display appears when the RCP PREVIEW switch is pressed once but cannot be
turned off.
(If the PREVIEW switch is turned on from another RCP, the preview display can be
switched.)
5. Set the MODE switch to 0.
1-7. Setting Up
AT
+5
MODE
SETUP DOWN CANCEL
CHARACTER
PHASE
SET/CANCEL switch
UP/DOWN switch
MODE switch
OFF Page9,11-Link cancel
OFF
RCP preview MOMENTARY & ALTERNATE
1 : MON 2 : ALT 3 : ALT1
OFF
OFF
OFF
INTERNAL MODE SETTING