Filter
Top Products
1-29 (E)
BKP-7933
1-7-8. Using the Tally System
Description of Operation
Set the menu as follows when you want to construct a tally system using the S-BUS. When this setting is
executed, the red tally and the green tally signals are accepted through the S-BUS and are output to the
corresponding CCU and camera in the form of command signals. Do not connect any cable to the
TALLY connector of the CCU. However, be careful when using the tally system as the response speed
of the tally system may become slower.
m
. When you want to use the green tally lamp on the front panel of the CCU, the CCU needs to be modi-
fied. Refer to the maintenance manual separately available.
. Refer to the installation manual of the Tally Interface Unit BKDS-7700, Section 3-2-4, “Tally Configu-
ration” for details of the tally system.
Connecting Peripheral Equipment
CCA-5
CABLE
REMOTE
RCP/CNU
REMOTE
RCP/CNU
CCU-550
S-BUS BNC (BELDEN 8281)
CCU-700A
CNU-700
with BKP-7933
CCU 1 to 6
REMOTE
S-BUS
REMOTE
SWITCHER
DIGITAL VIDEO SWITCHER
DVS-7000
TALLY INTERFACE UNIT
BKDS-7700
PRIMARY
STATION
1-7. Setting Up