Filter
Top Products
1-35 (E)
BKP-7933
1-8. Data Backup/Restore
m
. The description in this section assumes that BKPF-R70 is used as the primary station.
. The setup data of the unit is backed up and restored by using the BZR-10 (software for data backup)
supplied with the BKPF-R70.
. In this section, a lower-case letter is used in the sample screens. If you want, you can type with a
capital letter unless otherwise specified. Not type quotation marks (“ ”) but only 1 when the procedure
describes as follows; Type “1”.
The sample screens use roman letters, boldface letters, and symbols according to the follows.
Sample Description
C:\> Message displayed automatically by a program
install c: Characters to be typed by user
" Enter key/Return key
\ Space bar (One space is made.)
1-8-1. Installing the BZR-10
BZR-10 operates on the MS-DOS version 6.2 or in the DOS mode of Windows95.
Use the IBM PC/AT compatible personal computer in which the terminal software has been already
installed.
1. Insert the BZR-10 floppy disk (abbreviated as FD hereafter) in an FD drive of a personal computer.
2. Select the FD drive (Which is “A” drive in this document) in which the BZR-10 FD is inserted.
C:\>a:
"
3. Type as follows. The BZR-10 software is installed to the hard disk.
A:\>install c:
"
4. Type as follows. The mode enters the EDIT command.
Type “c:\router>” at the end of PATH. The PATH is added to AUTOEXEC.BAT file.
A:\>c:
"
C:\ROUTER> cd
\\
\\
\..
"
C:\>edit autoexec.bat
"
PATH C:\;C:
…
;c:\router
5. Save the AUTOEXEC.BAT file. Quit the edit command.
6. Remove the FD from the disk drive.
7. Use the Ctrl-Alt-Del key combination.
The personal computer restarts.
1-8. Data Backup/Restore