Filter
Top Products
Loading fanfold paper 11
Note that there is a guide inside the printer in front of the left tractor. The
▼
mark of the guide indicates where the left margin of the printing will be.
❏ Once the left tractor is aligned the way you want it, push the gray lever
back down to lock it in place.
❏ Now move the tractor on the right to the approximate position of the right
side of the paper you are using. Pull its gray lever up to unlock it, and push
the lever back down to lock it into place. Also move the center paper
support so that it is approximately halfway between the two tractors.
❏ Open the covers of both tractors and align the paper so that the pins on the
tractors are inserted into the holes of the paper.
❏ Close the tractor covers. At this point you can make final adjustments to the
paper position by releasing the gray levers and moving the tractors. The
paper should lie flat with no buckling or bulging (tractors too close) or no
stretching or elongation of the holes (tractors too far apart). After making
these adjustments, be sure that you re-lock the tractors by pushing the gray
levers back into their original positions.
❏ Plug the printer back into its AC power source. The printer will beep a
number of times to indicate that paper is not loaded.
Sheet guide Pin tractor