Filter
Top Products
Ifthepaperparkfacilitydoesnotappeartobeworkingcorrectly,checkthe
following:
ICheck
I Possible remedv
I
Is the paper release lever in
The paper release lever must be set to the ~ position
the ~ position?
after the fanfold paper has been parked.
Has the fanfold paper been
Make sure that the
“PAPEROUT’message comes on
properly pinked?
flashimzafter the fanfold uaoer has been uarked.
If textis beirtgprintedallon oneline,or withextrablanklines,checkthe
following:
Check
Possible remedy
Is the text all on the same
Carriage returns are not being expanded to <CR> +
tie?
<LF>
@S. Cheek the EDS setting and correct.
Istextbeingprintedwithextra
Twolinefedsarebeingprinted. Eithermakesure your
blank
lille.S?
software print just a carriage return or (if this is not
possible), set the AUTO LF to OFF with the EDS
setting.
Ifthepagelengthandmarginsarenotwhatisexpected,checkthefollowing:
Check
Possible remedy
1
Is the printingstartingtoo
Use the Micro Feed facility to adjust the print position
high or too low on the page?
relative to the page.
Doestheprinter’ spagelength
Use the EDS switches to set up the correct page lengti
not match the physical page or use software canrnands to do it.
length?
148