Filter
Top Products
Thermometer Error Message
B-2 8946121602
Port has a fault (fast flashing amber LED).
Port is OK (solid green LED).
Port is segmented (slow flashing green LED).
Port has an internal loopback (fast flashing green LED).
Port is sending data (flickering green LED).
Thermometer Error Message
Temperature out of range.
One or more faulty conditions have occurred.
Laser_Flt: the module is signaling a laser fault (defective GBIC);
Port_Flt: the port has been marked faulty (defective GBIC, cable or device)
Diag_Flt: the port failed diagnostics (defective G_Port card or motherboard)
The port is online and connected to a device over the cable.
Port is online but segmented.
Please check for loopback cable or incompatible switch.
The port is configured as a loopback port by diagnostics to verify the proper
functioning of the internal Fibre Channel port logic and paths between the interface
and the central memory. portEnable will put the port back online again.
The port is online and transmitting/receiving frames.
One or more temperature sensors have exceeded the minimum or maximum allowed
temperature reading (Minimum temperature is zero degrees Centigrade, maximum is 75o
degrees Centigrade).
Please check the temperature sensors inside the switch box.