Filter
Top Products
Chapter 1 Unpacking and Installing the Server 15
▼ To Install the Slide Rail Assemblies in a 19-Inch 2-Post Rack
1. Secure the front bracket with two No. 10-32 UNF screws.
Insert the rackmount securing screws no lower than 18.5 inches and 22.5 inches (47.0
cm and 57.2 cm) respectively.
Note – Mounting the bracket no lower than 18.5 inches and 22.5 inches allows for 10
inches of space beneath the server in order to service the backplane.
2. Secure the rear bracket with two No. 10-32 UNF screws.
3. Repeat Step 1 and Step 2 for the second slide rail assembly.
Installing the Server in a Cabinet
This section contains the following topics:
■ “To Prepare to Install the Server in the Cabinet” on page 15
■ “To Mount the Server in the Cabinet” on page 17
▼ To Prepare to Install the Server in the Cabinet
1. Remove the front bezel doors (FIGURE 1-8).
a. Open the door and press down on the hinge pin levers to release the hinges.
b. Lift the door off the hinge pins and store the door in a safe place.