Filter
Top Products
60 Netra 1290 Server Installation Guide • May 2006
FIGURE A-6 RJ-45 Serial Connectors
Note – Serial port B is reserved.
TABLE A-8 lists the settings needed to use the LOM Serial A connection. The
configuration of this port cannot be changed. Be sure to check the manufacturer’s
documentation for your specific terminal server. Communication on LOM Serial A is
subject to interruption by the LOM device. Refer to the Netra 1290 Server System
Administration Guide, 819-4374.
TABLE A-7 RJ-45 Serial Connector Pinout
Pin Signal
1RTS
2 DTR
3 TXD
4 Signal Ground
5 Signal Ground
6 RXD
7 DSR
8 CTS
TABLE A-8 Default Settings for Connecting to LOM Serial A
Parameter Setting
Connector LOM Serial A
Rate 9600 baud
Parity No
Stop bits 1
Data bits 8
LOM Serial A
Serial B
1818