Chapter 2 Setting Up 43
▼ To Bring the System to Standby Mode From the
Solaris Command Line
● At the system prompt, type:
▼ To Bring the System to Standby Mode From the
LOM Port
● At the lom> prompt, type:
● For an abrupt power off, type:
Caution – This abruptly brings the system to Standby mode, regardless of the
system state and might corrupt data on the hard drives.
▼ To Bring the System to Standby Mode by the
On/Standby Switch
Caution – The On/Standby switch does not isolate the equipment. Turning off the
power switch on the customer-supplied circuit breakers is required to isolate the
equipment.
● Press the left side of the system On/Standby switch.
# shutdown -i5
lom>shutdown
lom>poweroff
This will abruptly terminate Solaris.
Do you want to continue? [no]