Filter
Top Products
Chapter 3 Configuring Driver Parameters 43
To establish a forced mode for a speed of 10 Mbps and an autonegotiation mode for
duplex, type the following at the OBP prompt:
You could also type the following at the OBP prompt to establish the same local link
parameters as the previous example:
Refer to the IEEE 802.3 documentation for further details.
Sun Crypto Accelerator 4000
Cryptographic and Ethernet Driver
Operating Statistics
This section describes the statistics presented by the kstat(1M) command.
Cryptographic Driver Statistics
TABLE 3-12 describes the cryptographic driver statistics.
ok boot net:speed=10,duplex=auto
ok boot net:speed=10
TABLE 3-12 Cryptographic Driver Statistics
Parameter Description Stable or Unstable
vs-mode The values are FIPS, standard,orunitialized.
FIPS indicates that the board is in FIPS mode.
standard indicates that the board is in not in
FIPS mode. unitialized indicates that the board
is not initialized.
Stable
vs-status The values are ready, faulted,orfailsafe.
ready indicates that the board is operating
normally. faulted indicates that the board not
operating. failsafe indicates failsafe mode
which is the original factory state of the board.
Stable