Filter
Top Products
Chapter 4 Configuring the Network Software 49
3. At the ok prompt, type show-nets to list the network devices on your system.
You should see the full path name of the qfe devices, similar to the following
example:
4. Select the qfe device that you want to use as a boot device.
Using the show-nets command, select the letter of the device you wish to use. For
example:
Note – You need to select only one of these qfe devices for booting.
5. At the ok prompt type the boot command and the Control-Y key sequence to
paste the full path name of the selected qfe device.
You can either type boot and the full path name to the qfe device, or you can type
boot and press the Control-Y key sequence. In this example, the Control-Y key
sequence would be replaced by:
6. Press the Return key to boot the system over the qfe device.
ok show-nets
a) /pci@1f,0/pci@1/pci@1/pci@e/SUNW,hme@0,1
b) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1
c) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@2,1
d) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@1,1
e) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@0,1
f) /pci@1f,0/pci@1/pci@1/pci@b/SUNW,hme@0,1
g) /pci@1f,0/pci@1/pci@1/pci@a/SUNW,hme@0,1
h) /pci@1f,0/pci@1,1/network@3,1
i) /pci@1f,0/pci@1,1/network@1,1
q) NO SELECTION
Enter Selection, q to quit:
Enter Selection, q to quit: b
/pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1 has been selected.
Type ^Y ( Control-Y ) to insert it in the command line.
e.g. ok nvalias mydev ^Y
for creating devalias mydev for
/pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1
ok boot /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1