Filter
Top Products
Illustr.: Manual crimping tool for assembly
of Tyco Solarlok connectors
Contamination of any kind (dust, moisture,
etc.) has a negative effect on the working
order of the connector system over its aspi-
red service life. That especially applies to
the working order of the seals and the
crimping of the contacts. Therefore, make
sure everything is clean during assembly.
4.1 Tyco Solarlok Connectors
· Tyco Solarlok connectors may only be
connected to permanent lines!
· They may not be disconnected under
load!
· For this purpose, interrupt the electric
circuit at a suitable point! Put a corre-
sponding sticker on the lines near the
Tyco Solarlok connector!
· To avoid an electric shock, always
disconnect the Tyco Solarlok connec-
tors from all other voltage sources
during preparation!
!
Illustr.: Tyco Solarlok connectors
154
BP13370_NT_10000_englisch 23.11.2005 17:40 Uhr Seite 70