Filter
Top Products
4-16
X7DCL-3/X7DCL-i User's Manual
Event Logging
This setting allows you to Enable or Disable event logging.
ECC Event Logging
This setting allows you to Enable or Disable ECC event logging.
Mark DMI Events as Read
Highlight this item and press <Enter> to mark the DMI events as read.
Clear All DMI Event Logs
Select Yes and press <Enter> to clear all DMI event logs. The options are Yes
and No.
Console Redirection
Access the submenu to make changes to the following settings.
COM Port Address
This item allows you to specify which COM port to direct the remote console to:
On-board COM A or On-board COM B. This setting can also be Disabled. Note:
The default is On-board COM B if IPMI is enabled.
BAUD Rate
This item allows you to set the BAUD rate for the remote console. The options are
300, 1200, 2400, 9600, 19.2K, 38.4K, 57.6K, and 115.2K.
Console Type
This item allows you to choose Console Redirection type. The options are VT100,
VT100/8bit, PC-ANSI/7bit, PC ANSI, VT100+, VT-UTF8 and ASCII.
Flow Control
This item allows you to set the ow control for Console Redirection. The options
are: None, XON/XOFF, and CTS/RTS.
Console Connection
This item allows you to decide how Console Redirection is to be connected: either
Direct or Via Modem.
Continue CR after POST
This item allows you to decide whether you want to continue with Console Redirection
after POST routines. The options are On and Off.