Filter
Top Products
Additional commands (Printer) Status and error messages
T5023/5023+ - Programming Guide 229
The command CSI n ) t should always be used when only one print line
can be made available to the printer and for this reason performance
problems arise.
The control point is acknowledged when the last mechanical task is
started.
For example, a print task is acknowledged when all the conditions for
correct execution of the print line are fulfilled, this means:
– Data is transferred;
– Document edges are measured;
– Feeds are executed;
– Paper is present;
– Lid is closed;
– Print procedure is started.
By means of an earlier release of the acknowledgement signal it is pos-
sible for the workstation to request a new task from the system earlier
and to transfer it to the printer during the time in which the last mecha-
nical procedure has not yet terminated.
i