Filter
Top Products
Installing Modular Bay Accessories
Installing Internal Accessories 3-11
Changing modules
Follow these steps to change modules.
1. Turn off the computer.
2. Press the release latch on the right side of
the computer.
3. Lift the front of the computer slightly and
pull out the accessory currently in the
modular bay.
4. Remove the new accessory from its carrying
container.
Note: If you are installing the cellular battery
charger or organizer module, follow instructions
to insert the product into the module first. Refer
to your installation instructions.
5. Slide the new accessory into the modular
bay and push the accessory until it latches
into place.
6. Place the original accessory into an optional
carrying container if available and store in a
safe place.
7. Turn on the computer.
release
latch
eug-3.frm Page 11 Thursday, January 23, 1997 3:26 PM