Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
8
PRECAUTIONS
1. Installation
1
The e-STUDIO210c/310c should be installed by a qualified service technician.
Note: The packing material should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings.
220–240V, 50/60Hz, 9A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
3
After a suitable place has been selected for the installation of the e-STUDIO210c
/310c, please do not change it. Avoid excessive heat, dust, vibration and direct sun-
light. Also, provide proper ventilation as the copier emits a small amount of ozone.
Notes:
1. The recommended environmental range for use is as follows:
• Temperature: 10~30°C/50~86°F
• Humidity: 20~85% RH
2. To insure optimal operation, allow clearances of at least 80cm on the left, 80cm on the right and 10
cm in the rear (refer to the illustration below).
The socket outlet should be installed near the equipment and be easily accessible.