Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
9-24
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
3
Pull out the grip of the saddle stitch holder ( ) to-
ward you and turn it ( ) 90
o
clockwise in the direc-
tion of the arrow.
4
Remove the empty staple case and set a new one.
- Replace both staple cases with new ones.
- Do not remove the seal holding the staples before the staple
case is set in the cartridge.
5
Return the saddle stitch holder and the saddle
stitching unit to their respective original positions.
6
Make sure that the finisher is attached to the copier
firmly and that A3, B4 or A4-R size paper is set in
the copier.
- If one of the above paper sizes is not set, test stapling cannot
be performed.
If test stapling fails to be performed and the following mes-
sage remains displayed, repeat the above procedure from
steps 1 to 7.
Set staple cartridge
2
Slide out the saddle stitch unit carefully toward the
front.
7
Close the lower cover of the finisher. Test stapling
is then automatically performed on a blank sheet.
- This operation is carried out to avoid empty stitching.
6. ADDING STAPLES (OPTIONAL) (Cont.)