Filter
Top Products
e-STUDIO281c/351c/451c
(2) Enter adjustment mode [05]. Change the values for codes [1769 to 1772] to assign the highlighter-specific
mode function for a button in the "ONE TOUCH ADJUSTMENT" option.
* First, request the user to select a button ([VIVID], [CLEAR], [WARM] or [COLD]) to assign the
highlighter-specific mode function for.
Button to assign the highlighter-
specific mode function for
[05] code Mode to assign
Acceptable
value range
Default
[VIVID] 05-1769
[CLEAR] 05-1770
[WARM] 05-1771
[COLD] 05-1772
0: Default
1: MARKER 1
2: MARKER 2
0 to 2 0
* Two types of highlighter-specific modes are available. "MARKER 1" is intended to sharply contrast
between "yellow and green" or between "pink and purple" in similar hues, because yellow and green are
difficult to contrast in default mode. "MARKER 2" is intended to improve the overall vividness,
compared to "MARKER 1." Select either of modes at a user’s request.
* Setting "0" for each code allows the adjustment to be performed in accordance with the name of the button.
(For instance, setting "0" for code 05-1769 is intended to provide more vivid copy images.) But once any
value other than "0" is set for the codes, the output will no longer be obtained in accordance with the name
of the button.
* When "1" or "2" is set for the codes, the buttons in the "ONE TOUCH ADJUSTMENT" option will be
renamed. (For instance, provided that "1" is set for code 05-1769 to assign "MARKER 1"for the [VIVID]
button, "MARKER 1" will appear in place of [VIVID] in the "ONE TOUCH ADJUSTMENT" option.)
• After assigning the highlighter-specific mode function for the button, use steps (a) to (b) and press the
Highlighter-specific mode button in the "ONE TOUCH ADJUSTMENT" option.
(a) Press the [IMAGE] button on the Control Panel. Press the [ONE TOUCH ADJUSTMENT] button.
(b) Press the button where the highlighter-specific mode function is assigned.
After selecting highlighter-specific mode, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must use the next procedure.
2. Copier-specific Adjustments
2.12