Filter
Top Products
248
Using Hibernation
❖ When I press the power button
Set this option to Hibernation so that the computer goes
into Hibernation mode when you press the power button.
❖ When I close the lid
Set this option to Hibernation so that the computer goes
into Hibernation mode when you close the display panel.
5 Click Override all Modes with settings here.
6 In the Set to range dialog box, do one of the following:
❖ Click DC only for the settings to apply only when you
are using battery power.
❖ Click All for the settings to apply whether you are using
battery power or outlet power.
7 Click OK.
8 Click OK again, then close the Control Panel.
NOTE: For more information about the Power Saver utility,
see “Toshiba Power Saver utility” on page 176.
Starting again from Hibernation
To start up the computer from Hibernation mode, press the power
button until the on/off light turns green. The computer returns to
the screen you were using.
If you activate Hibernation by closing the display panel, you can
restart the computer by opening the display panel.