Filter
Top Products
1
2
3
4
5
Turning Power ON/OFF
25
Saving energy when not in use – energy saving modes -
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Refer to the MFP Management Guide for changing the default settings noted above.
For the European version
Contact your service representative to change the default settings noted above.
Energy saving
modes
Procedure to switch
modes
Conditions to enter into
the mode
Status of equipment
Conditions to recover
from the mode
Automatic Energy
Save mode
When a specied period of
time
*1
has passed since
the last use of the
equipment.
–
"Saving energy - press
START button" appears on
the touch panel.
When a button on the
control panel
*5
is pressed
or when print data or fax
data are received.
Sleep mode
When the [ENERGY SAVER]
button
*7
is pressed or
when a specied period of
time
*2
has passed since the
last use of the equipment.
When a particular option
*3
is installed or when a
particular protocol
*4
is
enabled.
"Saving energy – press
START button" goes o
and the [ENERGY SAVER]
button lights in green.
Same as the Automatic
Energy Save mode.
Super Sleep mode
When the [ENERGY SAVER]
button
*7
or the [POWER]
button
*6
is pressed or
when a specied period of
time
*2
has passed since the
last use of the equipment.
When a particular option
*3
is not installed and also
when a particular protocol
*4
is disabled.
Only the MAIN POWER
lamp lights.
When the [POWER] button
is pressed and held until
the ON/OFF lamp lights,
when print data or fax
data are received through
a wired LAN or when the
time set for Scheduled
Print has come.
*1 The default value set at the factory shipment is 3 minutes for e-STUDIO555 and 5 minutes for e-STUDIO655/755/855.
*2 The default value set at the factory shipment is 3 minutes for e-STUDIO555 and 10 minutes for e-STUDIO655/755/855.
*3 Any of the Wireless LAN Module, Bluetooth Module and e-BRIDGE ID Gate.
*4 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. Refer to the TopAccess
Guide for details.
*5 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*6 Even if you press the [Power] button, the equipment may not enter into the Super Sleep mode and the power may be turned OFF, depending on the
state of the equipment. Refer to the TopAccess Guide for the conditions under which the equipment enters into the Super Sleep mode.
*7 [ENERGY SAVER] button on the control panel shown below.
When the set period of time for switching to the Automatic Energy Save mode and that for the Sleep mode or the Super
Sleep mode are the same, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of
time.