Filter
Top Products
User’s Manual 6-12
TOSHIBA AT100
Removing a memory media
The following instructions apply to all types of supported media devices.
To remove a memory media, follow the steps as detailed below:
1. Make sure all file operations are finished.
2. Tap Apps -> Settings -> Storage -> Unmount SD card.
3. Press the memory media until you hear a click.
4. Release the memory media to partially extend it out of the tablet.
5. Grasp it and pull it out of the slot.
SIM card slot
Some models are equipped with a SIM card slot that allows you to
assemble a SIM card from your wireless service provider to use your
provider’s mobile networks for transmitting data.
Inserting a SIM card
To insert a SIM card, follow the steps as detailed below:
1. Turn off your tablet. Remove the cover and the battery pack as
described in the Removing the battery pack section.
2. Locate the SIM card slot beside the battery pack slot.
3. Slide your SIM card into the SIM card slot with your finger as shown on
the figure below.
You can slide the SIM card with your finger in the opposite direction to
remove the SIM card.
■ Make sure memory media is oriented properly before you insert it.
If you insert the media in wrong direction, you may not be able to
remove it.
■ When inserting memory media, do not touch the metal contacts.
You could expose the storage area to static electricity, which can
destroy data.
■ Do not turn the tablet off or switch to Suspend Mode while files are
being copied - doing so may cause data to be lost.
■ Do not remove the memory media while the tablet is in Suspend mode.
The tablet could become unstable or data in the memory media could
be lost.
■ Do not remove only the miniSD/microSD Card while leaving the
adaptor in the memory media slot.
This section only applies to models with 3G modules.