Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33055
2.2 Assembling the Accessories
E2- 3
2.2 Assembling the
Accessories
2.2.1 Assembling the Supply
Holder Frame
The following procedure outlines the steps required to assemble the
Supply Holder Frame and attach the frame to the B-852 printer in
preparation for loading the media.
1. Assemble the Supply Holder Frame (L) and Supply Holder Frame (R)
to the Supply Holder Base using the two M-4X6 Wing Bolts supplied,
as shown below.
2. Attach the assembled Supply Holder Frame to the rear of the B-852
printer by inserting the hooks of the Frame into the two slots in the
rear of the printer as shown in the figure below.
NOTE:
Make sure that the two small flanges
at each end of the Supply Holder
B
ase fit into the small rectangular
holes at the bottom of the Supply
H
older Frames before tightening the
Wing Bolts.
NOTE:
A
fter attaching the supply holder
f
rame to the printer, make sure that
it is assembled firmly.
Supply Holder Base
Supply Holder Frame (L)
Supply Holder Frame (R)
Wing Bolt
Hook
Hook