Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33055
2.4 Loading the Media
E2- 7
2.4.2 Installing the Supply
Holder Unit onto the
Supply Holder Frame
2.4.3 Loading Media into the
Printer
1. Insert the assembled Supply Holder Unit into the rear notches of the
Supply Holder Frame as shown in the diagram below.
2. Now feed the media from the bottom of the media roll into the media
slot at the rear of the printer as shown.
The following paragraphs outlines how to properly install the media into
the printer from the Supply Holder Unit that has been installed in the
previous steps.
1. Raise the Top Cover as shown in the diagram below.
CAUTION!
The reassembled Supply Holder
Unit and media roll may be quite
heavy, so be careful not to pinch
your fingers when installing the
Supply Holder Unit onto the
Supply Holder Frame.
Top Cove
r
NOTE:
Make sure that the brass bushings of
the Supply Shaft are seated into the
notches so that the entire Supply
H
older Unit rotates smoothly.
Supply Holder
Frame
Brass Bushing
Rear Notch
The Top Cover can be opened
during the operation for control
p
urposes only. It should be
closed during normal operation.
WARNING!