Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33055
2.4 Loading the Media
E2- 6
2.4.1 Installing the Media
onto the Supply Holder
Unit (Cont.)
The diagram below, and the steps that follow, show the procedures for
installing the Media onto the Supply Shaft and reassembling the Supply
Holder Unit. Be sure to follow the step-by-step procedure exactly or the
auto centering mechanism may not work properly.
Installing the Media and reassembling the Supply Holder
1. Place the media roll onto the Supply Shaft with the media feeding
from the bottom as shown in the diagram above.
c
2. Align the tab of the Removable Supply Holder with the Slot in the
Supply Shaft, then reinstall the Removable Supply Holder by sliding it
onto the Supply Shaft as shown in the figure above.
3. Holding the reassembled Supply Holder Unit in your right hand, apply
pressure only to the reinstalled Removable Supply Holder to push it in
the direction of arrow
d, causing the auto centering mechanism to
center the media on the Supply Shaft.
4. Tighten the green Supply Holder Locking Knob for the Removable
Supply Holder by turning it in the direction of arrow
e.
5. Tighten the green Supply Holder Locking Knob for the Non-
removable Supply Holder by turning it in the direction of arrow
f .
NOTES:
1. This Supply Holder accepts four
sizes of media core: 38 mm, 40
mm, 42 mm and 76.2 mm..
When using a media roll of 38
mm, 40 mm, or 42 mm, remove
the spacers from the Supply
Holders by pushing both hooks o
f
the Spacer. Keep the removed
Spacers safe.
2. Use only inside wound label
s
tock. Outside wound label stock
may not feed properly. Use
outside wound label stock at your
own risk.
3. Do not over-tighten the green
Supply Holder Locking Knob.
If you turn the Removable Supply
Holder side down after loading
the media, the media may drop
by weight. You might be injured
by the dropped media.
WARNING!
CAUTION!
When installing the media roll, do
not push on the Non-removable
Supply Holder as this will result in
the media roll not being properly
centred
.
Non-removable
Supply Holder
Removable
Supply Holder
Green Supply Holder
Locking Knob
Media Roll
Supply Shaft
Print Side
Slot
Tab
Spacer
Supply Holde
r