Filter
Top Products
2 HOW TO MAKE COPIES
46 Making Copies
When the number of sheets exiting has exceeded 250
To prevent exiting paper from falling off the receiving tray, the equipment causes copying to
pause when approx. 250 sheets of paper have continuously exited. At this time the [START]
lamp is lit and the [FUNCTION CLEAR] lamp blinks on the control panel. Also the paper jam
position lamp ( ) at the middle is lit.
Remove the paper from the receiving tray, and then press the [START] button. Copying
resumes.
Press the [FUNCTION CLEAR] button to end the copy job.
When the paper has run out
When the paper in the drawer has run out during copying, the copying stops and the paper
empty lamp blinks.
The [DRAWER] lamp corresponding to the one whose paper has run out blinks.
Add paper to the drawer and press the [START] button. Copying then resumes.
Stopping/Resuming copying
Press the [CLEAR/STOP] button to stop scanning or copying.
1
Press the [CLEAR/STOP] button during scanning or copying.
Scanning or copying stops. Press the [CLEAR/STOP] button again to end the copy job.
2
Press the [START] button to resume the copy job.