Filter
Top Products
COPY FUNCTIONS
20
Auto paper select mode (Two-tray model only)
When the AUTO PAPER SELECT indicator ( ) lights up, "Auto paper select mode" is enabled. This function
automatically selects the paper that is the same size as the original A5, A4, A4R, B4, A3 (ST, LT, LTR, 8-1/2" x
13", LG and LD) paper. "Auto paper select mode" can be disabled in the user programs. (p.33)
• The sizes of paper that can be loaded vary by country and region.
• If a zoom setting is selected after placing the original, the paper size that is appropriate for the zoom setting will
be automatically selected.
• "Auto paper select mode" is cancelled if the automatic ratio selection is enabled (p.22) or if a tray is selected
with the [TRAY SELECT] key ( ). Auto paper select resumes operation when the [RESET] key ( ) is
pressed or when "Auto clear time" activates.
Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight
up as shown. To replace the cover, do the reverse.
The ADF cannot be removed.
Copying books or originals with folds or
creases
Press down on the document cover/ADF while
copying as shown. If the document cover/ADF is not
completely closed, shadows may appear on the
copy or it may be fuzzy. Straighten originals with
folds or creases well before placing.
Originals that can be used in the ADF
Originals that are A5 to A3 (ST to LD) and 56 g/m
2
to 90 g/m
2
(15 lbs. to 24 lbs.) can be used.
A maximum of 40 pages can be placed at once.
For originals that are B4 (LG) or larger (B4, A3 (LG,
LD)), a maximum of 30 pages can be placed at
once.
Originals that cannot be used in the ADF
The following originals cannot be used. These may
cause misfeeds or smudging and unclear images.
• Transparencies, tracing paper, other transparent
or translucent paper, and photographs.
• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal
transfer printing), originals on thermal transfer
paper.
Stream feeding mode
If "Stream feeding mode" is enabled in the user
programs (p.33), the ADF indicator will blink for
about 5 seconds after all originals are fed. If a new
original is placed in the ADF during this time, the
original will be automatically fed in and copying will
begin.
• Make sure that there are no paper clips
or staples on the original.
• Straighten curled originals before
placing them in the document feeder
tray. Curled originals may cause
misfeeds.
Note