Filter
Top Products
User’s Manual 9-11
Qosmio F50 Series
8. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning on the power section in
Chapter 3, Getting Started, if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power, if required).
4. Push the latches away from the module in order to release it.
5. Grasp the memory module by its edges and remove it from the
computer.
6. Seat the memory module cover in place and secure it with one screw.
7. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power, if required.
8. Turn your computer over.
Battery Packs
You can increase the portability of the computer with additional battery
packs so that, if you’re away from an AC power source and your battery
runs low, you can replace it with a freshly charged battery. Please refer to
Chapter 6, Power for further information.
Universal AC Adaptor
If you frequently use your computer at more than one site, it may be
convenient to purchase an additional AC adaptor to be kept at each site in
order to remove the need to always carry the adaptor with you.
The slot A is reserved for main memory. Use the slot B for expanded
memory. If only one card is installed, use the slot A.
■ If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
■ Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Take care to ensure that the memory module cover is firmly closed.