Filter
Top Products
User’s Manual 9-19
Qosmio F50 Series
Precautions
■ Make a back-up of your data before transferring it to the computer.
There is a possibility that the original data will be damaged. There
is a particular risk that some frames will be deleted in the case of
digital video transfer. TOSHIBA assumes no liability for such loss
of data.
■ Do not transfer data in areas where static electricity is easily
generated or in areas subjected to electronic noise. Data can be
destroyed.
■ If you are transferring data through an IEEE1394 hub, do not
connect or disconnect other devices from the hub during data
transfer. There is a likelihood that data will be damaged. Connect all
devices to the hub before you turn on the computer’s power.
■ You may not use any copyrighted video or music data copied from a
video camera except for your personal enjoyment.
■ If you connect/disconnect an i.LINK device to/from another i.LINK
device that is currently exchanging data with the computer, data
frames might be dropped.
■ Make sure data transfer has ended or turn off the computer,
before you:
■ Connect/disconnect an i.LINK device to/from the computer.
■ Connect/disconnect an i.LINK device to/from another i.LINK
device that is connected to the computer.
Connecting the i.LINK (IEEE1394) cable
To connect the i.LINK (IEEE1394) cable, follow the steps as detailed below:
1. Make sure the connectors are properly aligned and plug the i.LINK
(IEEE1394) cable into the computer.
Figure 9-13 Connecting the i.LINK (IEEE1394) cable into the computer
2. Plug the other end of the cable into the device.
i.LINK (IEEE1394) connector
i.LINK (IEEE1394) port