Filter
Top Products
Replacement Procedures
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-32
Install the top assembly
The following describes the procedure for installing the cover assembly (See Figure 4-19 to
4-21).
1. Install the top assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the top of computer.
• M2.0×6.0 BIND screw Back x9
4. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.0×6.0 BIND screw Back x5
• M2.5×10 BIND screw Back x6
• M2.5×4.0 BIND screw Back x2
• M2.0×3.0 FLAT BIND screw Back x3
5. Free the cable from cable-drain when through the antenna cable to PCB hole.