Filter
Top Products
Replacement Procedures
4.11 Touch pad
Remove the touch pad
The following describes the procedure of removing the touch pad (See Figure 4-22).
1. Peel off the glass tape and disconnect the touch pad flat cable, finger print cable
from the connector on the touch pad.
2. Remove the following screws securing the touch pad plate and touch pad board.
• M2.0×3.0 Flat screw x4
• M2.0×3.0 BIND screw x4
M2.0
×
3.0 4screws
M2.0
×
3.0 Flat 4screws
Figure 4-23 Remove the touch board and touch pad plate screw
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-39