Filter
Top Products
Replacement Procedures
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-38
Install the display assembly
The following describes the procedure for installing the display assembly (See Figure 4-13 to
4-17).
1. Insert the pole of hinge to the hole of hinge assembly, set the display assembly on the
base assembly.
2. Secure the hinges with the following screws secure the display mask with the
following screws and stick the mask seal on them.
• M2.5×5.0B BIND screw x2
NOTE: Be sure to apply the lock tight to the screws instructed in the
figure above.
3. Connect the LCD harness to the connector on the system board.
4. Arrange the wireless antenna cables along the guide (front) and secure them with
guide.
5. Pass the cables to the back of computer through the slot.
6. Arrange the wireless LAN antenna along the guide and contact with the connector.
7. Install the LAN board and top ASSY of the system.