Filter
Top Products
4 Replacement Procedures 4.11 North Bridge Thermal Module
4.11 North Bridge thermal module
Removing North Bridge thermal module
Remove the north bridge thermal module according to the following procedures and Figure
4-31.
1. Remove the EMI tape from north bridge thermal module.
2. Disconnect the cable of the north bridge thermal module from CN511 on the system
board.
3. Release two thermal module securing screws.
4. Release two clips.
5. Remove the north bridge thermal module.
Figure 4 -31 Removing the north bridge thermal module
4-42 EQUIUM M40/M45 / Satellite M40/M45 Maintenance Manual