Filter
Top Products
Toshiba Corporation Digital Media Network Company
Page 107 of 153
© 2003, Copyright TOSHIBA Corporation All Rights Reserved
11.8.42.5 SMART Execute Off-line Immediate
COMMAND CODE
1 0 1 1 0 0 0 0
REGISTER
REGISTER SETTING NORMAL COMPLETION
DR DRIVE No. no change
CY C24Fh no change
HD no change
SN Subcommand specific no change
SC no change
FT D4h no change
This command causes the device to immediately initiate the activities that collect SMART data in an
off-line mode and then save this data to the device's non-volatile memory, or execute a self-diagnostic test
routine in either captive or off-line mode.
The sector Number register will be set to specify the operation to be executed.
SMART EXECUTE OFF-LINE IMMEDIATE Sector Number register values
Value Description of subcommand to be executed
0 Execute SMART off-line routine immediately in off-line mode
1 Execute SMART Short self-test routine immediately in off-line mode
2 Execute SMART Extended self-test routine immediately in off-line mode
3 Reserved
4 Execute SMART Selective self-test routine immediately in off-line mode
5-126 Reserved
127 Abort off-line mode self-test routine
128 Reserved
129 Execute SMART Short self-test routine immediately in captive mode
130 Execute SMART Extended self-test routine immediately in captive mode
131 Reserved
132 Execute SMART Selective self-test routine immediately in captive mode
133-255 Reserved
11.8.42.5.1 Off-line mode
The following describes the protocol for executing a SMART EXECUTE OFF-LINE IMMEDIATE
subcommand routine (including a self-test routine) in the off-line mode.
a) The device executes command completion before executing the subcommand routine.
b) After clearing BSY to zero and setting DRDY to one after receiving the command, the device will not set
BSY nor clear DRDY during execution of the subcommand routine.
c) If the device is in the process of performing the subcommand routine and is interrupted by any new
command from the host except a SLEEP, SMART DISABLE OPERATIONS, SMART EXECUTE
OFF-LINE IMMEDIATE, STANDBY IMMEDIATE or IDLE IMMEDIATE command, the device suspends or
aborts the subcommand routine and service the host within two seconds after receipt of the new
command. After servicing the interrupting command from the host the device may re-initiate or resume
the subcommand routine without any additional commands from the host.
d) If the device is in the process of performing a subcommand routine and is interrupted by a SLEEP
command from the host, the device will suspend or abort the subcommand routine and execute the
SLEEP command. If the device is in the process of performing any self-test routine and is interrupted by
a SLEEP command from the host, the device will abort the subcommand routine and execute the SLEEP
command.