Filter
Top Products
Toshiba Corporation Digital Media Network Company
Page 53 of 153
© 2003, Copyright TOSHIBA Corporation All Rights Reserved
11.7.5 Sector Number Register
- CS0 DA2-DA0 : 3 Read / Write
The target logical sector number (starting from 1) for Read, Write, and Verify commands is set in this
register. After completion of a command, it shows the sector number of the last sector transferred to the
host.
The starting sector number is set in this register for multi-sector operations. But when error occurs during
multi-sector transfer, it shows the number of the sector in which the error has been detected. During
multi-sector transfer, the number of the next sector to be transferred will not necessarily be shown.
In LBA mode, this register contains Bits 0 - 7 logical block address. After completion of a command, the
register is updated to reflect the current LBA Bits.
11.7.6 Cylinder Low Registers
- CS0 DA2-DA0 : 4 Read / Write
11.7.6.1 Disk Access command
Lower 8 bits of the starting cylinder number(starting from 0) for Read, Write, Seek, and Verify commands are
contained in these registers. After completion of the command or sector transfer, the current cylinder is
shown in this register.
In LBA mode, Bits 8 - 15 of the target address in logical block address are set in this register. After
completion of a command, the register is updated to reflect the current LBA Bits 0 - 7.
11.7.6.2 SMART commands
This register should be set to 4Fh for SMART commands
11.7.7 Cylinder High Registers
- CS0 DA2-DA0 : 5 Read / Write
11.7.7.1 Disk Access command
The high order bits of the starting cylinder number (starting from 0) for Read, Write, Seek, and Verify
commands are set in this register. After completion of the command or sector transfer, the current cylinder
is shown in this register.
In LBA mode, Bits 16 - 23 of the target address in logical block address are contained in this register. After
completion of the command, it shows the Bits 0 - 7 of the last logical block address.
Cylinder High Cylinder Low
Register Bits 7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
Cylinder Bits 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0