Filter
Top Products
Toshiba Corporation Digital Media Network Company
Page 32 of 153
© 2003, Copyright TOSHIBA Corporation All Rights Reserved
11.3.3 Signal Treatment
Driver types and requirements for the signal pull- up and down are as follows. Resistor requirement is minimum for the
host. - IO16 is pulled up in the drive with certain value so that the Vol is obtained to run with a host that has large value of
pull up resistor. - CS0 and - CS1 are also pulled up for better noise immunity.
Table 11.3-2 Signal treatment
SIGNAL Driven by TYPE By host By drive
- RESET Host TP 10k PU
DD 0:15
b
i-direction TS
DMAR
Q
Drive TS 5.6 k
Ω
PD
- DIOR Hos
t
TS
-DMARDY
HSTROBE
- DIOW Hos
t
TS
STOP
IORDY Drive TS 4.7 k
Ω
PU
-DDMARDY
DSTROBE
CSEL Hos
t
GND 10 k
Ω
PU
- DMACK Hos
t
TP
INTR
Q
Drive TS 10 k
Ω
PD
- IOCS16 Drive OD 1.0 k
Ω
PU 1.2 k
Ω
PU
DA 0:2 Hos
t
TP
- PDIAG Drive TS 10 k
Ω
PU
- CS0 - CS1 Hos
t
TP
- DASP Drive OD 10 k
Ω
PU
TP = Totem Pole, TS = Tri-State, PD = Pull Down, PU = Pull-Up, OD = Open Drain