Filter
Top Products
49
Getting Started
Adding memory (optional)
If no memory slot is available, you must remove a module by
performing steps 2-3 of “Removing a memory module” on page 51.
If your system has the memory modules stacked on top of one
another, you must remove the top module first before
removing/installing the bottom module.
13 Pick up the memory module by its sides, avoiding any contact
with its connector. Position the module toward the socket,
aligning the connector’s notch with the matching key in the
socket.
(Sample Illustration) Aligning the memory module with the socket
14 Firmly press the memory module into the memory slot’s socket
at approximately a 30-degree angle (to the horizontal surface
of the computer).
(Sample Illustration) Inserting the memory module into the socket
15 Once the module’s connector is fully inserted into the socket,
press downward on the top edge of the module to seat the
module into the latches at the sides of the socket. These latches
should “snap” into place securely with the corresponding
cutouts in the side of the module. If the latches and cutouts do
not line up correctly, repeat steps 14-15.
NOTE
NOTE
latch
latch
key
notch
connector