Filter
Top Products
174
6 F 3 B 0 3 6 2
Table A.5 Detailed Information (Ethernet Port Error Responses)
Error Code
Description
Normal complete 0001H Request completed normally
Local port fault 0002H The local port is in down mode
Local port standby 0003H Data transmission in standby mode (socket interface transmission or PC link
protocol transmission) was requested.
Timeout 0020H Timeout occurred during TCP open processing or receive processing, or during
UDP receive processing.
Length error 0030H Incorrect send data length
Port mode error 0040H One of the following requests was issued in a mode other than standby mode:
a. Parameter setup, b. MAC address setup, c. Reset
MAC/IP not set up 0050H
Occurs if the MAC address or IP address is not set up.
Transmission prohibited state 0060H • Occurs if a PC link request was issued from the T2N in run mode in the
message transmission prohibited state.
• Occurs if a socket open, close, send, or receive request is issued by the T2N
in run mode in the socket interface transmission prohibited state.
Format error 0070H Occurs when there is a format error in the request text.
0071H Port number error
0072H Request code error
0073H Time setting: Year
0074H Time setting: Month
0075H Time setting: Day
0076H Time setting: Hour
0077H Time setting: Minute
0078H Time setting: Second
Opened 0080H Occurs if an open request is issued for an already open socket.
Unopened 0081H Occurs if send, receive, or close request is issued for an unopened socket.
Incorrect socket identifier 0082H Occurs if the socket identifier is out of range (1 to 8).
Incorrect control request
specification
0083H Occurs if a request that was prohibited by an operating mode control request is
issued.
• Occurs if a run request is issued in run mode.
• Occurs if a standby request is issued in standby mode.
• Occurs if a run request and a standby request are issued at the same time.
LAN controller driver error 0090H Occurs if the setting of the local port IP address and port number in the area
reserved for transmission fails.
0091H Error in the TCP or UDP protocol (such as a transmission phase error)
0092H • Occurs if the setting of the remote port IP address in the remote port
information area (the NETDATA table) fails.
• Occurs if the remote port IP address network address differs from the local
port IP address network address.
Memory pool allocation failure 00A0H Occurs if the Ethernet Port internal OS fails to allocate memory.
Port 2 task start failure 00A1H Occurs if computer link or PC link socket identifier acquisition fails.
Broadcast specification error 00A2H If the remote destination was specified to be broadcast in a remote port
verification request.
MAC address specification error 00B0H BCC error
00B1H
Occurs if an error occurs after address saving on a MAC setup request.
Insufficient resources error 00C0H Occurs if there are insufficient resources for UDP send or PC link transmission.