Filter
Top Products
27
6 F 3 B 0 3 6 2
3.1 Connecting to the Network
The Ethernet Port supports 10BASE-T network.
(1) Connection to a 10BASE-T Network
This section describes the connection procedure starting from the state where the 10BASE-T
twisted pair cable is already supplied and ready to be connected. See section 9.2, "Network
Wiring", for details on wiring the 10BASE-T twisted pair cable.
10BASE-T connection
connector
PU235N/245N
Ethernet Port
To HUB
Twisted pair cable
Figure 3.1 Connection to a twisted pair cable
(1) Align the twisted pair cable with the 10BASE-T connector and insert the modular connector.
(2) Pull the 10BASE-T connector and verify that the connector is locked and cannot be pulled
out.
CAUTION
1. When installing a 10BASE5, 10BASE2 or 10BASE-T network, the cabling must be laid with adequate
safety precautions and in accordance with all applicable standards. Installation and wiring should be
performed by a qualified professional.
See the ISO/IEC8802-3 standard for installation environment standards.
Usage Recommendations
1. Do not exceed the maximum cable length (100 m) in systems using 10BASE-T.
2. A HUB and a twisted pair cable are required in systems configured using a 10BASE-T network.
(See section 3.2, "Network Wiring Equipment.")
These parts must be ordered separately if required.