Filter
Top Products
User’s Manual 7-3
HW Setup and Passwords
To delete a user password:
1. Select Not Registered to display the following prompt:
S Enter Password:
2. Enter the currently registered password. The character string you enter
is displayed as a string of asterisks.
S Enter Password: ****
3. Click the OK button. If the character string you enter matches the
registered password, the password option is reset and the display
changes to:
S The password was deleted
If they do not match, the following message appears. You must repeat step 1.
S Incorrect Password
4. Follow the same procedures described in the earlier section, How to set
the password, to set a new user password.
Parallel/Printer
Some models are equipped with Parallel/Printer tab. This tab lets you set
the Parallel Port Mode. Use the Windows Device Manager to make settings
for the Parallel port.
Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
If you click the OK button before entering the password, Registered will
appear on the display.
If you enter the password incorrectly three times, the screen will display:
Sorry, access denied!!! Powering off your machine then
powering it back on again are required to regain
access.
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
ECP Sets the port type to Extended Capabilities Port
(ECP). For most printers, the port should be set
to ECP. (Default)
Standard
Bi-directional
This setting should be used with some other
parallel devices.