Filter
Top Products
Installation
NOTE: If you are updating from an older version of CoPilot
®
, you will need to uninstall the
older version first. Refer to the Uninstalling section, pages 7-8.
To install CoPilot, first turn on your computer (and the external CD-ROM drive if
necessary) and insert the Install CD. Have the Installation Key Code from the front of the
CoPilot CD holder ready. NOTE: Do not lose this number. You will need it for
installation and registration.
Windows 95, 98, If the Installation menu does not automatically open, click on the
2000, ME: Start box and choose Run from the menu. Type your CD-ROM
drive letter, a colon, and "\setup" (example: d:\setup).
Windows NT 4.0: Choose Run from the File menu, then type your CD-ROM drive
letter, a colon, and "\setup" (example: d:\setup).
Choose Install CoPilot in the panel that appears and follow the installation instructions.
After CoPilot has been installed, you will be prompted to install the speech software. Click
OK and follow the on-screen directions. After installation is complete, it is recommended
that you install the Data to your hard drive.
You may choose to install either the East or West Data CD to save space on your hard
drive. A full installation of both Data CDs requires approximately 1 GB of available space.
If space in unavailable, you can run the program by inserting one of the Data CDs into your
CD-ROM.
NOTE: It is not necessary to select Change POI Set during the initial installation. Use this
option at a later time to change the POI set (page 18).
To start CoPilot, double-click on the CoPilot 2002 icon that was created on your desktop
when you installed the program. To quit at any time, select Exit from the File menu in
Planning Mode, or Quit CoPilot in Guidance Mode.
- 5 -