Filter
Top Products
12
Off Power is not connected
Green The port is connecting with the device.
Blinks The port is receiving or transmitting data.
LNK/ACT
Off No device attached.
Orange The port is operating in Full-duplex mode.
Blinks Collision of Packets occurs in the port.
FDX/COL
Off In half-duplex mode
Table 2-1. The Description of LED Indicators
Rear Panel
A module slot, 3-pronged power plug, 2 fans, a power switch button, and a console port
are located at the rear Panel of the TEG-S3000i chassis switch as shown in Figure 2-1.
The Switch will work with AC power in the range of 100-240V AC, 50-60Hz.
Figure 2-1. The Rear Panel of the TEG-S3000i chassis switch
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface
where you put your Switch should be clean, smooth, level and sturdy. Make sure there
is enough clearance around the Switch to allow attachment of cables, power cord and
air circulation.