Filter
Top Products
46
provides you can centralize the control of the switch in the network. For the manager
personal, he/she can save the time and easily on switches controlling.
MAC Address Ageing Time:
MAC address table refresh time setting. Type the
number of seconds that an inactive MAC address remains in the switch’s address
table. The valid range is 0, 300~765 seconds. Default is 300 seconds.
Broadcast Storm Filter mode:
configure the broadcast storm filter mode. The
valid threshold values are 5%, 10%, 15%, 20%, 25%, and N/A. The port will be
block cause of broadcast packet is over the percentage of traffic.
Max Bridge Transmit Delay Bound:
Limit the packets queuing time in switch. If
enable, the packets queued exceed will be drop. Press
Space
key to set the time.
This valid value are 1sec, 2sec, 4sec and off. Default is off.
Low Queue Delay Bound:
Limit the low priority packets queuing time in switch. If
enable, the low priority packet stays in switch exceed Low Queue Max Delay Time,
it will be sent. Press
Space
key to enable or disable this function.
Low Queue Max Delay Time:
To set the time that low priority packets queuing in
switch. Default Max Delay Time is 255ms. The valid range is 1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control” is enabled before enable Low
Queue Delay Bound, because Low Queue Delay Bound must be work under “Max bridge
transit delay bound control” is enabled situation.
Collisions Retry Forever:
Disable – In half duplex, if happens collision, the switch
will retry 48 times and then drop frame. Enable – In half duplex, if happens collision,
the switch will retry forever
Hash Algorithm:
This Hash Algorithm is for hardware maintain on MAC table
calculation. Provide CRC or Direct Map
IFG compensation:
Disable or Enable
IP Stacking Group ID (0…65535):
assign the stacking group ID. The switches
must assigned the same stacking group ID to be stacked as a group.
IP Stacking Mode:
enabling/disabling the stacking function. There are three
stacking modes. Any port on the switch can be used to stack. To configure the
switch in stacking group, please use the Web GUI configuration interface.
¾
Disable:
The stacking function is not working.
¾
Master:
There must have a leader switch to control all other switches in