Filter
Top Products
82
Switch basic setting interface
Advanced Setting
In Advanced setting, it has two sections – MAC Table Address Entry and Priority Queue
Service. After the configuration, click
Apply
button to complete the configuration.
Enable MAC address Aging Out:
to enable the MAC address age out function.
When it is disabling, the following configure item will not function.
Age-out Time:
fill in the number of seconds that an inactive MAC address
remains in the switch's address table. The valid range is 300~765 seconds.
Default is 300 seconds.
Max Bridge Transmit Delay Bound Control:
limit the packets queuing time in
switch. If enable, the packets queued exceed will be drop. This valid value are
1sec, 2 sec, 4 sec and off.
Enable Low Queue Delay Bound:
limit the low priority packets queuing time
in switch. If the low priority packet stays in switch exceed Max Delay Time, it
will be sent. The valid range is 1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control” is enabled before
enable Delay Bound, because Enable Delay Bound must be work under “Max
bridge transit delay bound control is enabled” situation.
Broadcast Storm Filter:
configure broadcast storm control. Enable it and set
the upper threshold for individual ports. The threshold is the percentage of the
port's total bandwidth used by broadcast traffic. When broadcast traffic for a
port rises above the threshold you set, broadcast storm control becomes active.
The valid threshold value are 5%, 10%, 15%, 20%, 25% and off.