Tripp Lite B006-VUA4-K-R Switch User Manual


  Open as PDF
of 28
 
10
Mouse Port Switching Functionality
When enabled, the Mouse Port Switching Functionality allows users with scroll mice to
simultaneously switch the focus of the KVM, Audio and USB between ports by double-
clicking the scroll wheel on their mouse. When used, ports will be accessed in sequential
order(e.g.port1willswitchtoport2;port2toport3,andsoon).Asthisfunctionis
disabled by default, you have to enable it in the OSD. To enable the Mouse Port Switching
Functionality, follow the steps below:
1. Open the OSD menu by pressing the [Scroll Lock] key twice.
2. Press the [F6] key to access the OSD Settings screen.
3. Select the Mouse Switching Function option and press the [Enter] key.
4. When prompted to enter Yes or No, type in a [Y] and press the [Enter] key.
Hotkeys
Hotkeys allow you to switch functionality focus between ports using only the keyboard, as
wellasperformotherfunctionsontheKVMswitch.Thefollowingsectiondescribesthe
hotkeyfunctionalityavailablefortheB006-VUA4-K-R.Attheendofthissectionisatable
of all the available hotkeys.
Hotkey Setting Mode
All hotkey commands start by entering Hotkey Setting Mode. When in Hotkey Setting
Mode, the [Scroll Lock] and [Caps Lock]keyboardLEDsashinsuccessionandordinary
keyboard and mouse functions are suspended. Only hotkey related keystrokes can be per-
formed. To initiate Hotkey Setting Mode, perform the following command:
1. Press and hold down the [Scroll Lock] key.
2. While holding down the [Scroll Lock] key, press and release the minus [-] key.
3. After releasing the minus [-] key, release the [Scroll Lock] key.
Alternate Hotkey Setting Mode Activation Command
By default, the command to activate Hotkey Setting Mode includes the [Scroll Lock] and
minus [-] keys. This can be switched to include the [Ctrl] and [F12] keys by performing the
following command:
1. Activate Hotkey Setting Mode using the aforementioned command.
2. Press and release the [H] key.
A couple of seconds after releasing the [H] key, the activation command will be changed
to use [Ctrl] instead of [Scroll Lock], and [F12] instead of the minus [-] key. Once the
activationcommandischanged,youwillbeexitedfromHotkey Setting Mode. To change
the activation command back, simply perform the Alternate Hotkey Setting Mode Activation
Command again.
201004198 93-2947.indd 10 4/23/2010 3:26:53 PM
 previous next