Tripp Lite B006-VUA4-K-R Switch User Manual


  Open as PDF
of 28
 
6
Hardware Setup
Safety Instructions
• Readalloftheseinstructions.Savethemforfuturereference.
• Followallwarningsandinstructionsmarkedonthedevice.
• Donotplacethedeviceonanyunstablesurface(cart,stand,table,etc.).Ifthedevice
falls, serious damage will result.
• Donotusethedevicenearwater.
• Donotplacethedevicenear,orover,radiatorsorheatregisters.Thedevicecabinetis
provided with slots and openings to allow for adequate ventilation. To ensure reliable
operation, and to protect against overheating, these openings must never be blocked or
covered.
• Thedeviceshouldneverbeplacedonasoftsurface(bed,sofa,rug,etc.)asthiswillblock
its ventilation openings. Likewise, the device should not be placed in a built-in enclosure
unless adequate ventilation has been provided.
• Neverspillliquidofanykindonthedevice.
• Unplugthedevicefromthewalloutletbeforecleaning.Donotuseliquidoraerosol
cleaners. Use a damp cloth for cleaning.
• Thedeviceshouldbeoperatedfromthetypeofpowersourceindicatedonthemarking
label. If you are not sure of the type of power available, consult your dealer or local
power company.
• Donotallowanythingtorestonthepowercordorcables.Routethepowercordand
cables so that they cannot be stepped on or tripped over.
• Ifanextensioncordisusedwiththisdevicemakesurethatthetotaloftheampereratings
ofallproductsusedonthiscorddoesnotexceedtheextensioncordampererating.Make
surethatthetotalofallproductspluggedintothewalloutletdoesnotexceed15amperes.
• Positionsystemcablesandpowercablescarefully;besurethatnothingrestsonanycables.
• Tohelpprotectyoursystemfromsuddentransientincreasesanddecreasesinelectrical
power, it is recommended that you plug your devices into a Tripp Lite Surge Suppressor,
LineConditioner,orUninterruptiblePowerSupply(UPS).
• Whenconnectingordisconnectingpowertohot-pluggablepowersupplies,observethe
following guidelines:
—Install the power supply before connecting the power cable to the power supply.
—Unplug the power cable before removing the power supply.
—If the system has multiple sources of power, disconnect power from the system
by unplugging all power cables from the power supplies.
• Neverpushobjectsofanykindintoorthroughcabinetslots.Theymaytouchdangerous
voltagepointsorshortoutpartsresultinginariskofreorelectricalshock.
• Donotattempttoservicethedeviceyourself.Referallservicingtoqualiedservice
personnel.
201004198 93-2947.indd 6 4/23/2010 3:26:52 PM
 previous next