Filter
Top Products
http://www.tyan.com
32
ONBOARD
8. Connecting the Power Supply
Tyan recommends using an ATX power supply that conforms to industry
standard revision 2.01. The Trinity 400 motherboard comes equipped with one
onboard power connector. Figure 2-16 below shows an ATX power connec-
tor. When plugging in the power connector, make sure that the plastic clip on
the power connector is aligned with the plastic tab on the onboard connector
(see Figure 2-17 below). Make certain that you do not miss any
pins because if you do, you will void your warranty and cause damage to
yourself or your motherboard when you turn the system on. After connecting
the power, make sure the connector is seated firmly into its socket so it will not
become loose or fall off when the computer is jostled or moved.
You are done!
Other than checking the jumper settings and cable connections and putting
the case back on, you are done. Installing a new motherboard may sound
difficult, but by following these directions, you should have a fairly uneventful
time installing our products. If you do encounter problems, your dealer will be
able to help you, or you can consult one of our many technical support
resources (see page 8).
Figure 2-17
Figure 2-16
Chapter 2
Board Installation