Filter
Top Products
ADJUSTING THE SETTINGS ON THE SCAN MANAGER PRO 53
3. Put the pointer on the image and drag the mouse to enclose the
section you want in the scanned image.
As you drag the mouse, a dotted box appears on the image and the
size settings change to reflect the new output size area. You can also
type in the size settings boxes.
■ Width and Height—the measurements of the final image after
it’s scanned; for example, if you plan to print the image on a
typical piece of paper, the width and height are 8.5 and 11.0
inches
■ Units—units of measurement for the new area; click the drop-
down arrow and choose new units if you want
■ Resolution—the dots-per-inch (dpi) setting for the new area
■ Scale—the amount of enlargement or reduction of the image to
fill the width and height measurements; for example, if you select
a small area and have set the width and height to a paper size, the
scale automatically increases to enlarge the small image so it’s the
same size as the paper
A new Scan Info box on the lower left portion of the Scan Manager
Pro shows the information for the new area.
You can select multiple areas. A new Scan Info box appears for each
one.
The following figure shows an example of a manually selected area.
Note: When you manually select an area, the settings on the other
panels are for that selected area, not the whole image. For example,
the histogram on the resolution panel and the response curve on the
brightness and contrast panel refer to only your newly selected area.