Vivitek D8300 Series Projector User Manual


  Open as PDF
of 80
 
Page 5.2
Changing the lamp module
Turn the power OFF and allow the lamp to cool for 5 minutes.
8QVFUHZWKHFDSWLYH¿QJHUVFUHZVHFXULQJWKHODPSGRRr, and remove the door.
8QVFUHZWKHWZRFURVVKHDGVFUHZVVHFXULQJWKHODPSPRGXOHWRWKHSURMHFWRU
Lift the wire handle up and use it to pull out the lamp module.
)LWDQHZODPSPRGXOHSXVKLQJLW¿UPO\LQWRSODFH
TLJKWHQWKHWZRFURVVKHDGVFUHZV
/RFDWHWKHWZROXJVDWWKHERWWRPRIWKHODPSGRRULQWRWKHVORWVDQGUH¿WWKH
door. TLJKWHQWKH¿QJHUVFUHw.
1.
2.
3.
4.
5.
6.
7.
Notes
Always allow the lamp to cool
for 5 minutes before:
GLVFRQQHFWLQJWKHSRZHU
PRYLQJWKHSURMHFWRU
FKDQJLQJWKHODPS
There are no user-serviceable
parts inside the lamp module.
The whole module should be
replaced.
Only lamps supplied by
D8300 and
intended for this projector
should be used. Fitting any
other lamp could damage
both projector and lamp, and
will invalidate the warranty.
At the end of life, the lamp
will not strike, and the Issue
indicator on the control panel
ZLOOÀDVKUHGTypical lamp life
is 2000 hours)
Do not use the lamp for more
than 2000 hours, as this may
cause serious lamp failure,
damage the lamp module
and cause extra cost on
replacement.
Take care not to touch the
glass surface of the lamp
module. If you do accidentally
touch the glass, it should be
cleaned before use.
HID lamps produce high
intensity light. Do not look
directly at the light coming
from the lamp housing or the
lens.
Opening the lamp door will
switch the projector OFF. The
projector cannot be operated
until the door is fully closed.
 previous next