1
2
3
4
5
6
7
8
9
10
11
12
9-2
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
1.
DESCRIPTION OF THE FLASHING GRAPHIC SYMBOLS
The graphic display on the touch panel shows the
status of the copier. When one of the graphic sym-
bols flashes, take the appropriate action referring to
the page shown.
CHECK ORIGINALS symbol
Flashes when an original misfeed occurs inside
the reversing automatic document feeder (op-
tional). Page 9-9
BYPASS MISFEED symbol
Flashes when a sheet of paper fails to be fed into
the copier during bypass copying.
Page 9-12
REPLACE TONER CARTRIDGE symbol
Flashes when the toner cartridge runs out of toner.
Page 9-5
PAPER PATH MISFEED symbol
Flashes when a paper misfeed occurs on the
paper path inside the copier. Page 9-12
LARGE-CAPACITY FEEDER MISFEED
symbol
Flashes when paper fed from the large-capacity
feeder (optional) is misfed. Page 9-11
CASSETTE MISFEED symbol
Flashes when paper fed from one of the cas-
settes is misfed.
Page 9-10
STACK symbol
Flashes when sheets of paper copied on one
side are stacked in the automatic duplexer (op-
tional) during duplex copying (this flashing does
not indicate a paper jam). This symbol also flashes
when sheets of paper are left in the duplexer. In
this case, remove the paper from the duplexer.
Page 9-16
DUPLEXER MISFEED symbol
Flashes when a paper misfeed occurs inside the au-
tomatic duplexer (optional).
Page 9-15
TRANSFER BELT MISFEED symbol
Flashes when a misfeed occurs on the transfer belt.
Page 9-13
REPLACE TONER BAG symbol
Flashes when the toner bag becomes full of used
toner.
Page 9-7
SADDLE STITCH UNIT MISFEED symbol
Flashes when a paper misfeed occurs inside the
saddle stitch unit. Page 9-19
FUSER MISFEED symbol
Flashes when a paper misfeed occurs in the fuser
unit.
Page9-14
FINISHER/PUNCHING UNIT MISFEED symbol
Flashes when a paper misfeed occurs inside the fin-
isher (optional) or the hole punch unit (optional).
Page 9-17, 9-18
CALL SERVICE symbol
Flashes when inspection and maintenance by a ser-
vice technician become necessary.
Page 9-28