Filter
Top Products
Apx-15
Appendix F. Output Cable Keeper
The Output Cable Keeper extends approximately two inches above the face of the
MPC-20V series unit, and provides a convenient means to tie output cables in place, to
prevent cables from being accidentally disconnected.
To install the Output Cable Keeper on your MPC-20V series unit, please proceed as
follows:
1. Refer to the electrical safety warnings in Section 4 and at the beginning of this
user's guide, and then disconnect the input power supply cables from the MPC-20V
unit. Next, remove the output cables from the MPC-20V, noting the precise plug/
location where each output cable was plugged in.
2. Align the Output Cable Keeper with the face of the MPC-20V unit as shown in
Figure F.1 below. Note that there are two horizontally aligned screw holes at the
top of the MPC-20V unit, and two vertically aligned screw holes at the bottom of
the MPC-20V unit. Use the supplied mounting screws to securely attach the Cable
Keeper to the face of the MPC-20V unit.
3. Reconnect the output cables to the same locations where they were previously
plugged in, and then use a tie wrap to secure each output cable to the Cable
Keeper.
Managed Power Co
ntroller
MPC-20V
8.8.8
8.8.8
DEFAULT
AUDIBLE
ALARM
ON
DISPLAY
SELECTION
AMPS
KWATS
VOLTS
TEMP
INPUT A
INPUT B
AUX
1
AUX
3
REMOTE
DISPLAY
AUX
2
Ethernet
10/100
CONSOLE
Outlet Cable Keeper
Mounting
Screws
Mounting
Screws
Screw
Holes
Screw
Holes
Figure F.1: Installing the Output Cable Keeper (MPC-20V Series Units Only)